Search results for "Polyvinyl siloxane"
showing 3 items of 3 documents
In vitro investigation of the impact of remaining tooth structure on the tensile failure loads of overdenture copings
2019
Background The purpose of this in vitro study was to evaluate the impact of the remaining tooth structure on the retention of overdenture cast metal copings. Material and Methods A freshly extracted intact mandibular human canine (length 25 mm) was selected and endodontically treated. An incisal reduction of 4 mm with no ferrule preparation was performed and a post space of 12 mm was created. By using polyvinyl siloxane duplication material and autopolymerizing polymethylmethacrylate resin, ten resin teeth analogs (control group) were obtained. A second set of ten resin teeth analogs (group 1) was created by preparing on the original natural tooth a 360o ferrule design of 1 mm in height and…
Digital selection of composite resin shade using cross polarized photography and a standardized white balance gray reference card
2021
Purpose The aim of the present case report was to describe, through a clinical case, a step-by-step technique, for the digital selection of composite resin shades using cross polarization and white balance employing a standardized reference card. Case Description After intraoral impression, a digital diagnostic wax up was developed. A 3D printed cast was used to fabricate a lingual polyvinyl siloxane matrix. First a cross-polarized image of the contralateral central incisor was taken in RAW format, using a gray reference card. The digital image was manipulated using this card as a reference, to obtain reliable color values. The obtained color values, from the contralateral central incisor, …
Comparison of the effect of different medicaments on surface reproduction of two commercially available Polyvinyl Siloxane impression materials - An …
2013
Objective:To determine the effect of different retraction cord medicaments on surface detail reproduction of polyvinyl siloxane impression materials and compare this effect on any two brands of commercially available polyvinyl siloxane impression materials. Material and methods: Four stainless steel dies were made according to ADA specification no.19. Three dies were treated with aluminium chloride (5%), ferric sulphate (13.3%) and epinephrine (0.1%) while the fourth one was left untreated to serve as control. Two impression materials (Dentsply and 3M ESPE) were used. Results: All the three medicaments adversely affected the surface detail reproduction of both the brands of the polyvinyl si…